Setting the contact reel into the middle position

Fig 1: Setting Contact Reel Into Middle Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION: A new contact reel is supplied in the middle position with a locking screw installed. Check that the locking screw is fastened as shown.

• Undo the locking screw so that the contact reel can be turned.
• Turn the contact reel fully to the right.
• Turn the contact reel approximately three times to the left.
• The slot of the screw must then be in the 1 o'clock position, as shown.
• Secure the contact reel in this position with the locking screw.