Removing Seat Belt (Inertia) Reel With Seat Belt Tensioner
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying SRS Ignition Cable Connector From Seat Belt Tensioner And Seat Belt (Inertia) Reel With Seat Belt Tensioner Screw
WARNING:
The battery must not be connected when the ignition cable connector is being removed or installed.
WARNING:
Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected non-deployed seat belt tensioner. This could deploy it.
Remove:
- the SRS ignition cable connector from the seat belt tensioner (1).
- 1 seat belt (inertia) reel with seat belt tensioner screw (2).
WARNING:
Replace both seat belt (inertia) reels with seat belt tensioners after a collision. This applies even if no-one was sitting in the passenger seat.
Installation
When installing tighten the screw to 48 Nm .
WARNING:
The seat belt tensioner must never be taken apart, repaired or moved to another vehicle. For handling replaced seat belt tensioner, see Handling replaced SRS airbags / seat belt tensioners .