Fitting the fuel pump units

WARNING: This page is about a different variant/trim than selected.

Fig 1: Tool Indicator Tip Between Markings On Fuel Tank

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

new gaskets
the LH pump unit
the RH pump unit.

Grease all contact surfaces of the pump units' retaining nuts with Vaseline.

NOTE:

Do not apply Vaseline to the nut threads.

Tighten the nuts with 40 Nm . Use special tool 9995673 as a counterhold. The tool's indicator tip must be between the markings on the fuel tank in order for the placement of the pump units to be correct.

NOTE:

Make sure the pump units are correctly positioned so that the fuel gauge shows the correct value.