Reading Off Programming Data
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
This function can be used to read off programmed data and program data into the control module. The purpose of the programming is to adapt the control module to the car version or when the driver requests that certain adjustments are made to the settings.
NOTE:
Before replacing a control module all programmed data must be read off first if this is possible. The information will then be downloaded into the new control module after it has been installed.
The following data can be programmed into the control module or read from it:
- driver position (which side of car driver sits, left-hand or right-hand drive car)
- engine type (indicates if car has gasoline or diesel engine).
- passenger compartment ventilation filter (indicates whether the climate control system has a passenger compartment ventilation filter)
- passenger compartment temperature (adapts passenger compartment temperature in relation to the selected position on the passenger compartment temperature selector).
- blower fan speed (adapts blower fan speed control when the blower fan switch is in the AUT position).
NOTE:
A new control module must be programmed with the driver's position, if it isn't the green LEDs in the REC and AC buttons will flash and the climate control system will not be accessible to regulate the climate in the passenger compartment. After programming the driver position, it is necessary to carry out self-adjustment of the damper motors.