Connecting the Volvo Scan Tool (ST)
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
To connect the Volvo Scan Tool (ST):
- Ignition off.
- select DIAGNOS TEST to read and erase diagnostic trouble codes (DTCs) and self-adjust the damper motors
- select MONITOR TEST to continuously read off the values and status of control module input and output signals.
- select PROGRAM to program control module with information
- select ADJUST MOTORS to activate self-adjusting on the damper motors.
- select READ CM: ID to display the control module part number.
- install memory cassette
- select DIAGNOS TEST to read and erase diagnostic trouble codes (DTCs) and self-adjust the damper motors
- select MONITOR TEST to continuously read off the values and status of control module input and output signals.
- select PROGRAM to program control module with information
- select ADJUST MOTORS to activate self-adjusting on the damper motors.
- select READ CM : ID to display the control module part number.
- Connect the Volvo Scan Tool (ST) with a cable to the data link connector (DLC) located below the center console cover.
- select DIAGNOS TEST to read and erase diagnostic trouble codes (DTCs) and self-adjust the damper motors
- select MONITOR TEST to continuously read off the values and status of control module input and output signals.
- select PROGRAM to program control module with information
- select ADJUST MOTORS to activate self-adjusting on the damper motors.
- select READ CM : ID to display the control module part number.
- Ignition on.
- select DIAGNOS TEST to read and erase diagnostic trouble codes (DTCs) and self-adjust the damper motors
- select MONITOR TEST to continuously read off the values and status of control module input and output signals.
- select PROGRAM to program control module with information
- select ADJUST MOTORS to activate self-adjusting on the damper motors.
- select READ CM : ID to display the control module part number.
- Turn on power to the Volvo Scan Tool (ST).
- select DIAGNOS TEST to read and erase diagnostic trouble codes (DTCs) and self-adjust the damper motors
- select MONITOR TEST to continuously read off the values and status of control module input and output signals.
- select PROGRAM to program control module with information
- select ADJUST MOTORS to activate self-adjusting on the damper motors.
- select READ CM: ID to display the control module part number.
- Select language, car and group of functions using a multi-function menu.
- select DIAGNOS TEST to read and erase diagnostic trouble codes (DTCs) and self-adjust the damper motors
- select MONITOR TEST to continuously read off the values and status of control module input and output signals.
- select PROGRAM to program control module with information
- select ADJUST MOTORS to activate self-adjusting on the damper motors.
- select READ CM: ID to display the control module part number.
- select the system required using the multi-function menu
- select DIAGNOS TEST to read and erase diagnostic trouble codes (DTCs) and self-adjust the damper motors
- select MONITOR TEST to continuously read off the values and status of control module input and output signals.
- select PROGRAM to program control module with information
- select ADJUST MOTORS to activate self-adjusting on the damper motors.
- select READ CM: ID to display the control module part number.
- select function from another mult-function menu:
- select DIAGNOS TEST to read and erase diagnostic trouble codes (DTCs) and self-adjust the damper motors
- select MONITOR TEST to continuously read off the values and status of control module input and output signals.
- select PROGRAM to program control module with information
- select ADJUST MOTORS to activate self-adjusting on the damper motors.
- select READ CM : ID to display the control module part number.