Checking Equipment And Software

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that ignition is ON.

Check ECC control module power supply to #B5 and to ground terminal #A23 for an open-circuit according to Open-Circuit, Permanent Faults .

Check that programming equipment is correctly connected.

Check that the new software to be loaded is the correct version.

Remedy as necessary.

Erase diagnostic trouble codes (DTCs) before starting programming.

Fig 2: Identifying Connector B

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Climate Control Module Connectors Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Erasing Diagnostic Trouble Codes (DTCs)

Do you wish to erase diagnostic trouble codes (DTCs)

YES
Refer to Erasing Diagnostic Trouble Codes (DTCs)
NO
FAULT TRACING FAILED: The fault should have been detected and remedied. As this is not the case fault-tracing has failed. Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.