General Information About Programming

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying ECC Control Module

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Before replacing a control module all programmed data must be read out first if this is possible. This is so that the new control module can be programmed with the same data. Check all the variable parameters for the new climate control module.

The ECC control module can be programmed with certain information. The purpose of the programming is to adjust the control module to the car version or when the requests of the driver for certain adjustments to the settings.

For more information about the values, see Description of ECC Programmed Data .

Set the blower fan speed selector switch to AUTO.

Programming procedure

Select the desired setting from the list box and then press Continue to program the different settings and to receive more information about the different alternatives.

Other procedures:

Begin the programming procedure. Make one setting at a time. Work from the top of the list box to the bottom. Refer to Programming Driver Position (LHD or RHD) .
Read off all programmed alternatives. Refer to Reading Off the Programmed Values .
Exit without programming. OKAY: Troubleshooting has been completed.

Fig 2: Identifying VCT2000

Courtesy of VOLVO CARS OF NORTH AMERICA.

Select an alternative.

0
Refer to Programming Driver Position (LHD or RHD)
1
Refer to Programming the Engine Type
2
Refer to Programming the Passenger Compartment Ventilation Filter
3
Refer to Programming the Passenger Compartment Temperature
4
Refer to Programming the Blower Fan Speed
5
Refer to Selection Of Control Module Sensor Version When Programming the Sun Sensor
6
Refer to Selection Of Control Module Sensor Version When Programming the Speed Signal