Checking For An Open-Circuit
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
- Check the gray cable between terminal 10 at the control module connector and terminal 2 at the connector for the water pump. Check for an open-circuit according to Open-Circuit, Permanent Faults . Remedy the fault or replace the cable.
- Check the black cable between terminal 8 at the control module connector and terminal 1 at the water pump connector. Check for an open-circuit according to Open-Circuit, Permanent Faults . Rectify the fault or replace the lead.
- Check the gray cable between terminal 10 at the control module connector and terminal 2 at the connector for the water pump. Check for an open-circuit according to Open-Circuit, Permanent Faults . Remedy the fault or replace the cable.
Select "Continue" when the fault has been remedied.
- Continue
- Check the black cable between terminal 8 at the control module connector and terminal 1 at the water pump connector. Check for an open-circuit according to Open-Circuit, Permanent Faults . Rectify the fault or replace the lead.
Select "Continue" when the fault has been remedied.
- Continue