Check the Cable For Power Supply To The Glow Plugs
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the 8-pin connector from the control module.
- Connect an ohmmeter between terminal 3 and the yellow cable on the glow plug.
The ohmmeter should read approximately 0 Ω.
- OK
Refer to Checking Glow Plugs .
- NOT OK
Refer to Checking For An Open-Circuit