Programming Driver's Position (Left Or Right Hand Drive) (ECC): Notes

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: In order for a new ECC control module to operate the control module must be programmed for driver position (LHD or RHD). A control module that has not been programmed will not operate at all and the green indicator LEDs in the REC and AC buttons will flash.

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition on.
Use Programming function to program the ECC control module.
After programming the driver's position the AC button green indicator LED will flash until the throttle motor self adjustment is completed.

Fig 2: Identifying VCT2000
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Programming Driver Position (LHD Or RHD)
Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Self-Adjustment Of The Shutter Motor End Position