Signal Too Low: Verification

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

HINT: After carrying out the repair, check that the fault has been remedied.

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Connecting Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Disconnect Volvo Scan Tool (ST) from the VIDA unit. Use it as a stand-alone tool and connect to the car's data link connector (DLC).
Ignition off
Reconnect connectors, reinstall components.
Ignition on.
Wait at least 10 seconds so the control module can run diagnostics.
Read off the diagnostic trouble code (DTC) counters.
Check the values of the counters. If the value is greater than 0 the control module interprets this as there no longer is a fault present (intermittent fault). If the counter is 0 this indicates that there is an internal fault in the control module, and the fault is still there (permanent fault).

Fig 3: Identifying Scan Tool
Courtesy of VOLVO CARS OF NORTH AMERICA.

Is counter value greater than 0?

YES
VERIFIED: Troubleshooting has been completed.
NO
Refer to Information