Reading Off Data And Replacing Components
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Before replacing a control module, the programmed data must be read off first if this is possible.
- Ignition on.
- Use Programming function to read out all data from ECC control module and note down the values. These values must be used to program the new control module. For further information about programming, see Description Of ECC Programmed Data
.
Then try a new ECC control module according to Replacing ECC Control Module .
- Continue
Refer to Programming the ECC Control Module