Removing And Installing Stub Axle: Installation

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Nut On Ball Joint

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install

stub axle on the trailing arm
new nut on the ball joint. Tighten to 80 Nm . Use a Torx wrench as counterhold.

NOTE: Make sure that the mating surfaces on the ball joint and link are clean.

Fig 2: Identifying Drive Shaft Splines

Courtesy of VOLVO CARS OF NORTH AMERICA.

Clean the splines on the drive shaft.

Turn in the stub axle and locate the drive shaft in the hub.

Install drive shaft screw and finger-tighten. Lubricate the screw.

Install

both screws retaining the spring strut in the stub axle. Use new screws and nuts. Tighten to 105 Nm and angle-tighten 90° . Use bevel protractor 9512050
anti-roll bar link to the spring strut. Use a new nut. Tighten to 50 Nm
ABS sensor cable
ABS sensor onto stub axle. Tighten ABS sensor to 10 Nm
NOTE: Ensure that the sensor seat in the stub axle is absolutely clean. Clean the ABS sensor with a soft brush.

Fig 3: Tie Rod End On Wheel Spindle

Courtesy of VOLVO CARS OF NORTH AMERICA.

tie rod end onto the stub axle. Use a new nut. Tighten to 70 Nm .

brake disc. Tighten brake disc locating pin to 8 Nm .
NOTE: Ensure that the brake disk and wheel rim hub mating surfaces are clean.

Tighten drive shaft screw to 50 Nm . Use a screwdriver as counterhold on the brake disc.

Fig 4: Brake Caliper And Limiter Mounting Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

brake caliper and limiter. Use new screws. Tighten to 100 Nm
the wheel according to Installing wheels .