Diagnostic trouble code (DTC) information
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
IMM-132 Key codes
Condition
The control module checks if there are any key codes stored in the EEPROM memory circuit every time the ignition is switched on. Diagnostic trouble code (DTC) IMM-132 is stored if no key codes are stored. There are two reasons for diagnostic trouble code (DTC) being stored.
- The key codes have been erased from the EEPROM memory circuit and no other keys have been programmed in.
- The control module is not initiated.
The diagnostic trouble code (DTC) is erased automatically in normal function when the first key code is programmed into the control module memory.
The diagnostic trouble code (DTC) is erased when the counter value is one.
Possible Source
- The Immobilizer control module is not initiated.
- Faulty procedures when programming.
Fault symptom[s]
- The engine starts but stalls directly.