Diagnostic trouble code (DTC) information
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
IMM-112 Control module
Condition
The control module controls the EEPROM memory circuit for certain entries to the EEPROM memory. diagnostic trouble code (DTC) IMM-112 is stored if there are any faults in the memory circuit. Faults which cause diagnostic trouble code (DTC) IMM-112 to be stored can also cause diagnostic trouble code (DTC) IMM-121 to be stored.
The diagnostic trouble code (DTC) is erased when the counter value reaches 254.
Possible Source
- Fault in the control module memory circuit.
Fault symptom[s]
- The control module does not approve or cannot read the PIN when programming.
- New keys cannot be programmed.
- The engine starts occasionally, but not with a fault in a certain memory cell. Can mean a start with certain of the customers keys.