Replacing fuel tank pressure sensor

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fuel Tank Pressure Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Clamp Being Squeezed By Pipe Wrench

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the screw
Removing clamp:
- squeeze clamp with a pipe wrench. Hold in place
- pry apart with a small screwdriver.
  NOTE: It is reusable.
Remove clamp
NOTE: The clamp will be reused

Removing clamp:
- squeeze clamp with a pipe wrench. Hold in place
- pry apart with a small screwdriver.
  NOTE: It is reusable.
Disconnect hose.
Installing clamp:
- Press in the clamp with a pipe wrench until it locks.
Remove cable harness.
Installing clamp:
- Press in the clamp with a pipe wrench until it locks.
Install the new pressure sensor, route cabling as before.
Installing clamp:
- Press in the clamp with a pipe wrench until it locks.