Remove transmission torque rod screw

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Tie Rod End, Transmission Torque Rod Screw And Ball Joint To Control Arm Nuts

Courtesy of VOLVO CARS OF NORTH AMERICA.

tie rod end from right stub axle
the three nuts which hold the ball joint to control arm on right-hand side
right drive shaft and intermediate bearing cap from drive shaft, carefully place it on the steering servo pipes
the two screws for the right engine mounting (bend the right fender liner to one side slightly first)
the transmission torque rod screw

NOTE:

Install sealing plugs 9995488 in the holes left by the drive shafts.