Remove components

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Camshaft Components

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION:

Remove the ignition key from the ignition switch before beginning work.

NOTE:

The crankshaft or camshaft must not be rotated under any circumstances other than those listed below. Failure to follow these instructions may cause damage to the valves.

Remove:

the upper timing belt cover.
the servo reservoir and the expansion tank.
Lift up and place on top of the engine.

NOTE:
Take care not to spill servo oil from the bleed hole in the cap.

Place paper wipe around the reservoir and then cover with a plastic bag as protection.

Spilled servo oil is highly inflammable.
the auxiliaries belt.
the front camshaft belt cover.