Removing components
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
The illustration above shows a turbo engine.
Remove:
- the exhaust manifold.
- the cover over the ignition coils.
- the ignition coils.
Mark up and lay them aside without unplugging the connectors.
- the top and front timing belt casing.
- the engine cooling fan.
Loosen screw for clamp at throttle housing (ETM-unit) so that the charge-air pipe is not bent.
Press back the charge-air pipe and lift up the cooling fan with fan shroud.
- the inlet pipe.
- screw for the inner timing belt casing.