Secure the crankshaft position
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Install the adjustment tool
- Applies to turbo engines: Pull forward the charge-air pipe.
- Remove the starter motor's mounting screws, 3 pcs.
- Place the starter motor to one side.
- Remove the blind cover plug and the sealing washer.
- Turn the crankshaft clockwise slightly to avoid the adjustment tool being in the wrong position.
- Install adjustment tool
9995451
.
Make sure that it bottoms out against the engine block.
- Turn the crankshaft counter-clockwise until it stops against the drift.
NOTE:
Check that the marking on the crankshaft's
timing belt pulley matches the marking on the oil pump.