Install timing belt pulley with VVT-unit. Applies to turbo engines.

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Timing Belt Pulley, Center Screw And Plug

Courtesy of VOLVO CARS OF NORTH AMERICA.

Push on the timing belt pulley with the VVT-unit on the exhaust camshaft.
NOTE:
Also check that the markings match.
Fit the top timing belt casing to see that the markings match.
Tighten the center screw with 120 Nm .
Tighten the center plug with 35 Nm .
Loosen the screws securing the timing belt pulley in the VVT-unit.
Install the timing belt pulley on the inlet camshaft with two screws, but do not tighten.