Installing the clutch pipe on the junction

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Clutch Pipe Junction Retaining Clip

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the clutch pipe on the junction. Use a new seal. Ensure that the clip is seated in its groove.

Remove the hose clip.

Bleed the clutch

It may be difficult to bleed the pressure regulator. Use a bleeding unit.

Use only Volvo Genuine parts brake fluid DOT 4+.