LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2003 >> C70 2.3 53, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Engine - Removal, Replacement And Installation (Coupe)) >> Crank Mechanism (M56; 1998-2002) >> Flywheel, replacement >> Installing the gearbox >> Checking the steering gear bearing in the boot at the firewall

Checking the steering gear bearing in the boot at the firewall

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Steering Shaft Rubber Grommet
GLL102216Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that the steering gear bearing in the boot has not detached from the boot.

If it has become detached apply a little grease to the edge of the boot (around the hole). Press the bearing back down into the boot. See arrow in illustration above.

NOTE:

Check that the rubber boot is positioned correctly in the bodywork. Adjust if necessary.

There is a risk that noise from the gearbox or engine and road noise may enter the passenger compartment.

Connect the battery lead 

First read Battery, disconnecting .

Test driving