Driver Position
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
In order for a new ECC control module
to function, the control module must be programmed for the driver position (LHD or RHD).
A control module that has not been programmed will not operate at all and the green indicator LEDs in the REC and AC buttons will flash.
After programming in the driver position, the green LED in the A/C button will flash and continue to do so until the self-adjustment of the damper motor is complete.
Programmable data is: left-hand drive or right-hand drive . If the control module was not previously programmed no data can be read off.