LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2003 >> C70 2.3 53, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Climate Units - Removal, Replacement And Installation (Coupe)) >> Replacing Components. Additional Heater (1999-2002) >> Replacing Fuel Line >> Removing >> The Quick-Release Connector Between Fuel Hose And Fuel Line

The Quick-Release Connector Between Fuel Hose And Fuel Line

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Protective gloves and protective goggles should be used for the following operations because of the risk of fuel spillage.

Disconnect the quick-release connector between the fuel hose and fuel line under the fuel filter, by pushing the locking ring into the quick-release connector and pulling it apart.

Plug the quick-release connector by inserting the shaft of a 6 mm drill bit into it.

Install a rubber plug P/N 1346125 into the fuel line to reduce fuel spillage.

Unscrew the fuel line (11 mm wrench) from the heater fuel pump (counterhold 14 mm wrench).

Install a rubber plug P/N 1346125 into the fuel line to reduce fuel spillage.

scientia non olet · About LEMON Manuals