Installing the Receiver/Drier Or Suction Pipe, Common Operations
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
- Install the receiver/drier and suction pipe on the bracket
- Install the receiver/drier and suction pipe with the bracket on the side member
- Install the quick-release connector for the evaporator at the receiver/drier
- Install compressor pipe coupling. Tighten to 25.6 Nm
- Fill the system with refrigerant. See Refrigerant, Overview and Emptying/Vacuum Pumping/Filling With Refrigerant . Check for leaks.
- Install the air baffle
- Install fresh air hose on the control module box
- Install the battery negative lead.