Checking the Setting

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Adjustment Tool

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Press the tool down towards the flat surfaces below the thread on the shaft.

Remove the lever. Install adjustment tool 9995475 on the gear shift linkage rod. Check that the shaft is in the N position. The groove on the tool must align with the marking on the gear position sensor.

If adjustment is required, see the following procedure in this section.