Installing the control module

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Control Module And Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install (on the passenger side):

connect the connectors
the control module on the bracket
insert the control module at an angle. Position the bracket against the tunnel
NOTE:
Ensure that locking tab on the control module face goes into the groove on the bracket.

Fig 2: Identifying Heating Unit

Courtesy of VOLVO CARS OF NORTH AMERICA.

the screw holding the bracket on the tunnel
the two screws holding the control module on the bracket
the carpet brace
the soundproofing panel. See Dashboard
the glove compartment. See Disassembly

Install (on the driver's side):

the screw holding the bracket on the tunnel
the screw holding the bracket on the heating unit.

Fig 3: Identifying Control Module Box Fresh Air Intake Hose And Floor Carpet Mountings

Courtesy of VOLVO CARS OF NORTH AMERICA.

the carpet brace
the soundproofing panel. See Dashboard .

Finishing

Check that the system appears to be working normally
Check that no diagnostic trouble codes (DTCs) have been stored during the repair
If possible, allow the car to stand outside with the engine switched on and idling for approximately 15 minutes. This so that the control module can store the current position via the GPS system. When the control module has been stored the current position, it is shown on the display (if a CD-ROM disc with map information is in place).