Check, connectors and cables
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Check the control module connector and the display connector for contact resistance and oxidation according to Contact resistance and oxidation .
Check the cable between control module #A11 and display terminal 6 for an open-circuit according to Open-circuit, permanent faults , a short-circuit to ground according to Short-circuit to ground, permanent faults and a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults .
Remedy as necessary.
Other information:
- To access/replace the control module, see Replacing the control module, old system .
- To access/replace the display, see Replacing the display .
- For connecting breakout box, see Connecting the breakout box .
Was a fault detected?
- Continue
Refer to Verification