Connecting fuel pressure gauge

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Adapter Hose And Fuel Pressure Line Nipple

Courtesy of VOLVO CARS OF NORTH AMERICA.

Corrective actions:

Remove protective cap from the fuel pressure line nipple.
Install the adapter hose nipple loosely on the nipple on the fuel pressure line. The nipple will be tightened later.
Arrange hose as shown in the illustration.

CAUTION:

Ensure that the hose follows the rubber trim on the plenum chamber and then out of the engine compartment at the rear corner of the hood, with the adapter hose joint at the T-valve outside the engine room, so that neither the bonnet or the hose are damaged when the hood is closed. In addition check that hose cannot contact the throttle control reel.

Fig 2: Installing T-Valve To Left Door Mirror Using Tape

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the T-valve to the left door mirror using tape.
NOTE: Protect the door mirror and wing edge with foam protection as shown in the illustration.