Injector valve, replacement: Installing
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Install:
- All rubber damping elements on intake manifold.
- Fuel rail on the intake manifold.
- New screws and tighten to 10 Nm.
- Fuel line clamps.
- Remove tool holding the injector.
- Injector connectors. Check that each connector has a rubber seal.
- Covers over fuel rail and throttle pulley.
- B5234T/B5204T/B5234T5: Upper charge-air pipe.