Releasing the spring strut

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Catch For Control Arm Spring Strut

Courtesy of VOLVO CARS OF NORTH AMERICA.

For all:

Press down the control arm 9997076
Position the catch at (1). Release the spring strut from the control arm.

NOTE:

If the catch is placed by (2) the rubber boot on the ball joint may be damaged.

Fig 2: Identifying Spring Strut And Drive Shaft

Courtesy of VOLVO CARS OF NORTH AMERICA.

Press out the drive shaft completely. Hang up the spring strut using a retaining strap against the jacking point. Do not damage the ball joint boot. Hang up the drive shaft from a hook 9995045 .
Remove the splash guard under the engine.

Fig 3: Identifying Stub Axle CV Joint Housing Sealing Ring Installed

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION:

Later models have a rubber seal on the constant velocity joint. Do not damage the seal. It will be needed for installation.