Installing the left control arm
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
For all:
- Install the control arm. Use new screws
- Tighten the front screws. Tighten to: Tightening torque . Use protractor 9512050
- Tighten the rear screw and the nut. Tighten to: Tightening torque
Applies to cars equipped with the 4T65 EV/GT transmissions:
- Lower the engine
- Tighten the front engine mounting. Tighten to M10, 50 Nm .
- Remove the mobile jack