Removing lifting beams and the lifting hooks from the engine

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Gearbox Mounting Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Installing the remaining screws for the transmission and starter motor

Install:

the 4 x M10 screws for the transmission and engine. Tighten
the 2 x M10 screws for the starter motor. Tighten. See Summary of tightening torques for specific components .

Fig 2: Identifying Ground Lead, Coolant Hose, Charge Air Pipe And Clamps

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the hose and the clamp for the charge air pipe which are under the engine
the ground lead mounting on the subframe
the engine coolant hose to the pipe at the rear of the engine.

Connect the vacuum hose to the rear engine pad. Secure the hose to the transmission. Use a tie strap.

Tighten the clamp for the servo line on the subframe.