Installing the subframe on the bodywork
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use new screws. Lubricate the screw threads.
Lift up the subframe until it is about 150 mm from the side member.
Secure the power steering pipe at the front edge of the upper side of the subframe. Use the rubber covered clamp. Install the screw loosely. Apply a small amount of soap solution so that it glides into the clamp easily. Check the steering gear bearing in the boot at the firewall.
NOTE:
Ensure the following when lifting the subframe:
- that the steering gear screws align in the frame
- that the brake pipe passes the bracket for the exhaust pipe
- that the ball joint pinion for the spring strut aligns in the control arm.
Install:
- the new screws and the support bracket at the rear edge
- the screws loosely in the bracket.
Applies only to cars with fuel driven parking heaters:
Align the washer with the mounting lug following the marking on the subframe.
Tighten the subframe screws. Tighten to light contact.
Remove the mobile jack.