Installing the tools on the clutch

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Relieving Load From Clutch Diaphragm Spring Using Special Tools

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install counterhold 9995677 , see Aligning the counterhold for automatic clutch adjustment .

Install the compression tool 9995662 , see Installing the compression tool .

First tighten the center screw on the compression tool to light contact. Then compress the clutch.

NOTE:

When the center screw comes into contact with the diaphragm spring, the screw should, for a loose clutch, be tightened a maximum of 4-4.5 turns.

Applies only to certain engine versions with self adjusting clutches:

NOTE:

When the center screw comes into contact with the diaphragm spring, the screw should, for a loose clutch, be tightened 4.5 - 5 turns or until a clear click is heard .