General Information
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
By connecting the Scan Tool (ST) to the data link connector (DLC) it is possible to read out information on possible faults in the system as well as get other information. The Volvo Scan Tool (ST) communicates with the control module via a standard communications interface.
Connecting the Volvo Scan Tool (ST) is described in Volvo Scan Tool (ST) .
The data link connector (DLC) is located in the car.
To establish communication with the power seat control module the following conditions must be met:
- Battery voltage must be more than approx 11 V.
The ignition can be turned OFF.