LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2003 >> C70 2.3 53, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 169 (Electrical Connectors - Information & Repair (Coupe)) >> Electrical >> Volvo Scan Tool (ST) Scrolling Values

Volvo Scan Tool (ST) Scrolling Values

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

The table below contains the values which can be read off using the Volvo Scan Tool (ST).

No.  Text 
Unit of measurement 
Remarks 
1 SPEED=
km/h/mph
Vehicle speed.
2 FUEL. DA=
lit/gal
Attenuated fuel level signal. Signal to needle.
3 FUEL. NDA=
lit/gal
Unattenuated fuel level signal. Sensor output signal.
4 ECT=
°C
Engine coolant temperature.
5 RPM=
RPM
Engine speed in RPM.
6 D+=
HIGH/LOW
Generator charge voltage. A charge voltage above 10.8 V produces the value HIGH and a charge voltage under 4.3 V produces LOW. Undefined value for voltages between 4.3 and 10.8 V. The value LOW means that the charge warning lamp will also be lit when the engine is running.
7 OIL PRESSURE=
YES/NO
YES = Oil pressure in engine.
NO = No oil pressure, warning lamp lights.
8 LOW FUEL=
ON/OFF
ON = Warning lamp lights when fuel level is under approximately 8 liters.
OFF = Warning lamp does not light.
This parameter is not updated when the lamp check function is carried out.
9 SRL=
ON/OFF
ON = Signal to service reminder indicator (SRI), SRI lamp lights.
OFF = No signal to SRI lamp.
This parameter is not updated when the lamp check function is carried out.
10 TEMP. WARN
ON/OFF
ON = Signal to outside temperature warning lamp, lamp lights.
OFF = No signal to outside temperature warning lamp.
11 12 PULSE=
OK/NOT OK
OK = 12 pulse vehicle speed output signal OK.
NOT OK = Short-circuit to supply voltage in 12 pulse vehicle speed output signal
12 48 PULSE=
OK/NOT OK
OK = 48 pulse vehicle speed output signal OK.
NOT OK = Short-circuit to supply voltage in 48 pulse vehicle speed output signal
To obtain the relevant values the vehicle speed signal should be read off when the front wheels are rotating.
13 MANIPUL.=
NO/YES
NO = Vehicle speed signal is OK.
YES = Vehicle speed signal missing when engine coolant temperature (ECT) exceeds 50 °C and engine speed (RPM) exceeds 1500 RPM.
To obtain the relevant values the vehicle speed signal should be read off when the front wheels are rotating.
14 TEMP. NDA
°C
Outside temperature, unattenuated signal from sensor.
15 TEMP. DA
°C
Outside temperature, attenuated signal from control module.
16 FUEL. FLOW
pu
Fuel consumption signal in pulses per second.