Cable harness SRS system, repair: Notes
Special tools:
Materials: SRS system repair kit for the selected car.
The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.
As the SRS system is a safety system, it is extremely important that these instructions are carefully followed when carrying out repairs in the cable harness.
Ensure that the new pin has the same type of surface treatment as the old.
Only special tools and materials from the SRS system repair kit for the selected car must be used. Choose a repair location where there is plenty of room to guarantee that work is of the highest quality.
The cables should always be connected color to color. If the repair terminal colors do not correspond with the vehicle, check with the wiring diagram for the vehicle in question. In the cases where the repair terminals have a completely orange cable then this is always fitted to terminal No. 1. In the cases where the repair terminals have a blue and a brown cable, then blue is No. 1 and brown is No. 2.
Do not carry out any work on the SRS cable until the connector has been disconnected from the relevant airbag or seat belt tensioner. There is otherwise a risk of static electricity deploying the component.