Remove the Drive Shaft From the Gearbox

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Right-Hand Drive Shaft To Gearbox

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove:

the splash guard under the engine. See Remove the Splash Guard Under the Engine
the cover for the drive shaft pilot bearing.

Pull the drive shaft straight out from the gearbox.

NOTE: Do not damage the drive shaft when removing it from the transmission.

Fig 2: Identifying Rubber Seal On Constant Velocity Joint

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION: Later models have a rubber seal on the constant velocity joint. Do not damage the seal. It will be needed for installation.