Installing components in the steering gear and sub-frame

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Steering Gear Fasteners At Sub-Frame

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

new lock nuts and screws on the steering gear. Tighten to 50 Nm
the screw for the front engine pad. Tighten to 50 Nm
new screws for the torque rod mounting. Tighten to 35 Nm and angle tighten +40° .

Press the power steering line into the holders on the sub-frame.