Adjusting front toe angle

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Tightening Lock Nut, Outer Steering Arm Inner To Steering Arm Inner

Courtesy of VOLVO CARS OF NORTH AMERICA.

Adjust with the tie rods after loosening the lock nuts. Adjusting towards a positive value will give toe-in and towards a negative value toe-out. To obtain correct values on respective model variants, refer to Wheel camber, specifications .

NOTE: The lengths of the tie rods must not vary between themselves by more than 2 mm. Measure between the lock nut and the edge of thread.

Tighten the lock nut, outer steering arm inner to steering arm inner. See Tightening torque .

Treat the strut threads using rustproofing agent after tightening.