Installing the brake pipe, continued

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front-Rear Brake Pipe

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the brake pipe in the ABS hydraulic modulator. Tighten to 17 Nm
the brake pipe in its clips at the bracket. Adjust the pipe as necessary
the clip holder on the brake pipes by the side member
the bracket. Tighten to 12 Nm .

NOTE: The brake pipes must not be in contact with each other or the car body.

Check for leakage. Check that the ABS lines are correctly secured in their clips.

Install the wheel

See Installing wheels .