Transferring components

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Sub-Frame Transferring Components

Courtesy of VOLVO CARS OF NORTH AMERICA.

Transfer

the control arms. Use new screws and new nut. Tighten the front screws. Tighten to 65 Nm . Angle-tighten 90° . Use bevel protractor 9512050 . Tighten the rear screw. Tighten to 105 Nm . Angle-tighten 90°
the anti-roll bar. Tighten to 60 Nm
the right-hand engine mounting. Tighten the screws. Tighten to 65 Nm . Angle-tighten 60°
the mounting for the heated oxygen sensor (HO2S) wiring
the engine pad.

Install new pipe/hose holders.