Engine mount (rear), replacing: Preparation

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Engine Stabilizer Brace

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove

the screw for the engine stabilizer brace at the control arm on the engine
the screws at the engine stabilizer brace mountings at the suspension turrets
the engine stabilizer brace
the nuts for the front exhaust pipe connection to the turbocharger (TC). Carefully pull the exhaust pipe away from the turbocharger (TC) and hang it on the cowl panel.
NOTE:
The metal hose for the front exhaust pipe is easy to damage if it is twisted. Handle the exhaust hose with care to avoid leakage later.
the vacuum hose for the rear engine pad
the upper nut for the rear engine pad.

Fig 2: Identifying Splash Guard Under The Engine

Courtesy of VOLVO CARS OF NORTH AMERICA.

Raise the car.

Remove

the splash guard under the engine
the lower screw for the engine pad.