Right-Hand Drive Cars Only

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Impact Absorber Bolts

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the collision protection system above the steering gear (2 screws).

Fig 1: Identifying Subframe

Courtesy of VOLVO CARS OF NORTH AMERICA.

Lower the sub-frame approximately 100 mm.

Make sure that the 5 steering gear screws and the collision protection system screws release from the frame.

Remove the screws for the anti-roll bar's bearing cap (left-hand side). Loosen the screws on the right-hand side so that only a few threads remain.

Tie up the anti-roll bar tot he steering gear as illustrated.