LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2003 >> C70 2.3 53, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Axle Shafts, Transmission Control Module - Removal, Replacement And Installation (Coupe)) >> Replacing Pilot Bearing, Right Drive Shaft (M56; 1998-1999) >> Replacing pilot bearing, right drive shaft >> Installing the new circlip >> Insert the rest of the grease into the constant velocity joint

Insert the rest of the grease into the constant velocity joint

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Boot Clamp Installed Using Pliers
GLL108687Courtesy of VOLVO CARS OF NORTH AMERICA.
CAUTION:

Make sure that there is no grease on the mating surface of the boot on the sides facing the constant velocity joint and the shaft.

Pull boot on to the constant velocity joint and ensure it is correctly positioned on the drive shaft. 

Install new clamps 

NOTE:

Installing drive shafts, see Drive shafts, installing 

scientia non olet · About LEMON Manuals