Removing the left drive shaft

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Rubber Seal On Constant Velocity Joint

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION:

Later models have a rubber seal on the constant velocity joint. Do not damage the seal. It will be needed for installation.

Fig 2: Identifying Jimmy Bar

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the drive shaft from the transmission. Use lever 9995462 between the transmission and the inside of the drive shaft. The tool is modified as described in the Workshop Guide.

CAUTION:

Pull at the constant velocity joint, not the shaft, when removing the shaft. This is to help prevent excessive load on the joint axial stop. Take care not to damage the drive shaft seal and boots.