Removing the drive shaft from the hub
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Turn and fold out the spring strut. Tap the drive shaft end. Use a plastic or copper hammer. Pull the drive shaft out of the hub.
Clean the spline joint.
CAUTION:
Pull at the constant velocity joint, not the shaft, when removing the shaft. This is to help prevent excessive load on the joint axial stop. Take care not to damage the drive shaft seal and boots.