Installing the bracket for the brake pipe / ABS cable

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Brake Line/ABS Cable Bracket, Wheel Arch Liner Plastic Nuts & Torx Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the bracket for the brake pipe / ABS cable.

NOTE:

Ensure that the ABS sensor seating is absolutely clean

First clean the ABS sensor using a soft brush. Then install it on the stub axle. Tighten to 10 Nm .

Install the front wheel

See Tightening the wheel studs .